Other

A set of front lamp guards for series landrover.

A pair of rear lamp guards, very good used condition. Series 2a and 3.

Weber Kit for the Series 2a & 3 Landrover with 2.25 engines.
Kit No: 15290627

This is a complete clutch sleeve kit for the Fairey Overdrive (lt76). It contains the circlips, spacers and needle roller bearing.

Engagement Kit for the Fairey / Superwinch Overdrives.
This kit contains:
- Knob for Operatin Lever
- Operating Lever
- Locknut
- Pivot Kit
- Link ...

Soon available. Control Rod for the Iso Speedic Governor.

Series 2a/3 Mounting bracket for the Engine Governor. 

Stuf for the series 2/3 engine governors control levers.
 

Rod assembly for the series 2a/3 engine governors.
 
Please note, you could also get a copy of the original one for 79 EUR.

New Old Stock Optional Equipment Parts Catalogue in original packing.

Knob for operating lever of the Fairey and Superwinch Overdrive units.

Engine mounting bracket that is bolted to left hand side of engine block. These are original old stock parts with some surface rust, but perfectly ...

These are 2 Range Rover Classic /stage one, Fairey Overdrives. The units are for repair only. What you see is what you get.
 

This is a Range Rover Classic Fairey Overdrive. This is a complete unit, found the lever as well (not shown on the photos).

4 x Delphi Hand Brake Shoes 1964-84.

Hinge Pin Kit for Land Rover Series and Land Rover Defender - One Pin Including Spring and Nut

For sale are a set of 2 (LH & RH Side) military Series 2A hinges, for exterior mirror. Including the complete hinge kit.

Set of 7 detent springs for series and defender landrovers, rrc, discovery 1, lr230

For sale is the last series 1 engine governor. Used condition.
 

The Iso-speedic co. ltd Speed limiter.
To fit series II,IIa and III Land Rover2 1/4 4 Cyl.- 595/8 - 2427007
Ex Military
New Old Stock

Accelerator Rod Angle Bracket NOS

Bottom Radiator Hose NOS. FFR Series 2a.
For Series IIa upto engine suffix H inclusive. And from engine suffix J onwards.

Ball Joint for the iso speedic governor.

Alternator Pulley NOS for iso-speedic engine governor. Series 3.

Twin Groove Water Pump Pulley NOS. For Series IIa upto engine suffix H inclusive. And from engine suffix J onwards.

NOS Double Groove Crankshaft Pulley for 4 Cylinder Landrover (military).
For Series IIa upto engine suffix H inclusive. And from engine suffix J on...

pulley for engine governor, includes the bearing and nut.

Land Rover 2.25 engine Iso-Speedic engine governor jockey wheel support bracket.  
Please note this is only for Series IIa & III, not for Series II...

Belt adjusting plate 2.25 Petrol Engine

Series 1 Mounting bracket for the Engine Governor.

Polybush Set Serie Landrover. 1 set available.

Lower Spring Seat

Genuine NOS Km/h speedo for Series 2 and 3 LWB 7.50 Landrovers
I have 10 units left. Some show 2 or 3 km on the clock.

Used 2.25 bellhousing. Was glass bead blasted.

NOS RRC Door frame, LH Side.

Landrover Series 2 2a 3 Transfer Case PTO Cover

1 x New clutch sleeve for the Toro Overdrive (Bearmach Overdrive).
The clutch sleeve is heat treathed and case hardened.
 

Needle Roller Bearing for the Clutch Sleeve of the Toro Overdrive.

Landrover Serie Rear Mainshaft Gear + Nut 1948-84 1 out of 2 sets.
Blasted with glass beads - in good genuine used condition.

Landrover Serie Rear Mainshaft Gear 1948-84 1 out of 2.
Blasted with glass beads - in good genuine used condition.

Series Lifting and Towing Rings used on many military and civilian Series vehicles.

Clutch Master Cylinder Series / Defender

Series 1, 2 & 3 Gear lever knob for high / low ratio.

Starting handle for all 4 & 6 cylinder engine models except Military lightweight. Non V8 Stage One.

One Fairey / Superwinch Overdrive to Transfer Box Gasket.

One ball bearing for the mainshaft of the Fairey & Superwinch Overdrives.

A copy from a blue print of a series IIa Landrover. 
To be used for decoration purposes only.

Genuine NOS Grose-Jet Carburettor Float Valve for the Range Rover Classic.
The plastic has been opened to check content.

New old stock exhaust clamp for tail pipe.
Range Rover Classic

Crank case breather/flame trap assy.
101 Forward Control.
series 3 stage 1 V8 109" models
Defender 87> 90/110
Discovery 89-98
Range Rover Classic >...

New old stock clutch master cylinder repair kit.
Range Rover Classic 1970-74
Original Leyland Quality Parts.

New Dust Cover Ball Stud Steering Gear RRC

Variouse parts - unsure if the part number & package is correct. Parts look new, but some of them have light surface corrosion. Believed to be for ...